Residential · San Jose, CA
If your driveway is weathered but the base is still sound, asphalt resurfacing is the fast, cost-smart way to restore a smooth, solid surface. Apex Asphalt San Jose has served San Jose since 2018, installing asphalt overlays that address cracks, raveling, and low spots without full removal.
Good resurfacing starts below the mat. We inspect drainage, measure soft spots, and check for base failure (pumping, widespread alligator cracking, deep rutting) to confirm an overlay is the right fix. Prep typically includes saw-cut and remove failed areas, excavate and rebuild with aggregate base (Class 2), compact with a plate compactor or vibratory roller, then mill high edges where needed so the finished surface ties in cleanly at the garage, sidewalks, and curb. We clean with power brooms and blowers, treat cracks with hot rubberized crack filler, apply a tack coat (asphalt emulsion) for bond, then pave a new lift of hot-mix asphalt.
Local soils and heat cycles make water control and compaction critical. We correct drainage with proper cross-slope, feather transitions, and edge support so water does not sit and seep into the base. For most driveways, an overlay in the 1.5-2 inch range is common, with thicker builds in wheel paths or where heavy vehicles turn; we set thickness based on grade, existing conditions, and door clearances. After paving with an asphalt paver, we roll in stages with steel drum and pneumatic rollers to lock aggregate and reduce future raveling. Finish details include tight handwork at edges, clean joints, and a smooth, uniform surface ready for traffic after proper cool-down.
San Jose customers choose us because we do the unglamorous parts that make an overlay last. You get clear recommendations on overlay vs. remove and replace, itemized scope, and a written estimate so there are no surprises. Our crews show up with the right equipment, keep access as workable as possible, and focus on bonding, slope, and compaction rather than just laying a thin cap. Since 2018 we have helped homeowners, HOAs, and small businesses extend pavement life with practical resurfacing plans that fit real budgets.
Before we leave, we walk the site with you and verify tie-ins, drainage flow, and finished elevations at the garage and walkways. You receive basic care guidelines, including when to park, when to use trash bins, and what to avoid during the first weeks (sharp turns in place, kickstands, and heavy point loads). We also point out any areas to monitor, like existing concrete joints, utility cuts, and edges, and we can schedule optional sealcoating after the asphalt has cured. The result is a cleaner look, smoother ride, and a thicker wear surface that protects the base and slows future cracking.
Yes. We provide a free written estimate that lists the recommended scope, measured quantities, and the materials and steps included.
Yes. We regularly transition asphalt to garage slabs, sidewalks, and existing concrete, using clean sawcut edges where needed and proper compaction at the joint to reduce separation.
Repair scope depends on the failure, but may include sawcut and removal, base rebuild with aggregate, compaction, hot mix placement, and edge sealing. We can also add crack sealing and sealcoating where appropriate.
Yes. We stripe stalls, arrows, fire lanes, and accessible markings, and we can coordinate layouts for re-striping after paving or sealcoating.
Yes. For active businesses, we can phase paving or resurfacing, set cure windows, and plan access routes to reduce downtime.
Asphalt resurfacing, also called an overlay, adds a new layer of hot-mix asphalt over existing pavement to restore smoothness and improve durability without the cost of full reconstruction. Apex Asphalt San Jose evaluates whether your driveway structure can support an overlay, then uses proven prep, bonding, and compaction methods to deliver a tight, long-lasting surface in San Jose, CA.
Asphalt resurfacing works best when the existing pavement has surface cracking, raveling, minor settling, or oxidation, but the base is intact. If we find widespread base failure, severe rutting, or repeated heaving, we will recommend remove and replace in those sections before overlaying, or full reconstruction if needed. Our process typically includes cleaning, crack filling with hot rubberized material, patching failed areas, rebuilding base with compacted Class 2 aggregate where required, and applying an asphalt emulsion tack coat to ensure the new mat bonds to the old surface.
For the overlay itself, we place hot-mix asphalt with a paving machine to maintain consistent thickness, then compact with steel drum and pneumatic rollers to tighten the mix and reduce future deformation. We pay close attention to grades at the garage and walkway transitions, edge support, and water flow so the new surface performs through heat, traffic, and irrigation runoff. Thickness and details are set to your driveway conditions, vehicle loads, and clearance needs, not a one-size approach.
If you want a smoother driveway, fewer cracks telegraphing back, and a renewed look without starting from scratch, asphalt resurfacing is often the right middle ground. Contact Apex Asphalt San Jose for a free written estimate, and we will explain the best overlay plan for your property, including prep, thickness, drainage corrections, and realistic maintenance timing.
Call now or send a request and we will reach out within one business day to schedule your free, no-obligation estimate in San Jose. We assess the project, review the details, and give you a written quote before any work starts, so you know exactly what to expect.
Prefer to write? Contact us or head back to the home page.
